Procedure
1. If one or more motor(s) is stopped while the other(s) is running, shift the stopped motor into 'N' (neutral). 2. Tilt the stopped motor up so its propeller is above the water's surface. WARNING: If the propeller of the stopped motor is left in the water with its gearshift in 'R' (reverse) and the boat is moving forward, reverse flow of water from the exhaust side can occur, causing an engine malfunction.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · NEUTRAL, FORWARD, REVERSE
Diagnostic · Cause: One or more remote control levers may not be in NEUTRAL position Test: Verify all remote control levers are in the NEUTRAL position before attempting station transfer
Spec · 3,000 rpm conditions={"note":"Running below 3,000 rpm for more than 30% of operating time leads to water condensation and unburned fuel mixing with engine oil"}
Procedure · 1. Place all gearshift/throttle control levers in the NEUTRAL position. 2. Press and hold the [+] switch until one-lever mode is engaged. 3. Use the single gearshift/throttle control lever to shift gears and adjust en...
Diagnostic · Cause: Charging system fault Test: Inspect charging system (ACG) for malfunction