Specification
Engine: Break-in Phase 4 max continuous full-throttle duration
5 minutes conditions={"phase":"Next 8 hours","note":"Do not run at full throttle for more than 5 minutes at a time"}
Specification
5 minutes conditions={"phase":"Next 8 hours","note":"Do not run at full throttle for more than 5 minutes at a time"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Run the engine at trolling speed for the first 15 minutes. Use the minimum throttle opening necessary to operate the boat at a safe trolling speed. WARNING: Avoid continuous operation at a steady speed throughout t...
Diagnostic · Cause: Residual heat triggering the engine protection system after full-throttle operation Test: Restart the engine and monitor if the protection system deactivates on its own
Spec · 30 seconds conditions={"phase":"Next 60 minutes","note":"Bursts OK but no continuous full-throttle"}
Procedure · 1. Move the control lever(s) to the N (neutral) position. 2. After cruising at full throttle, cool down the engine by idling for a few minutes before stopping the engine. 3. Push the START/STOP switch to stop the engi...
Diagnostic · Cause: Starter motor operated continuously for more than 5 seconds Expected: Maximum 5 seconds of continuous cranking per attempt