Specification
Outboard Motor Cooling System: Minimum flush duration
10 minutes conditions={"water_type":"fresh water","method":"flush port connector"}
Specification
10 minutes conditions={"water_type":"fresh water","method":"flush port connector"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 4. Screw the flush port connector onto the garden hose. 5. Turn on the fresh water supply and flush the outboard motor for at least 10 minutes. 6. After flushing, disconnect the garden hose and reconnect the flush por...
Diagnostic · Cause: Possible cooling system fault Test: Check cooling system indicator on p. 50; stop engine immediately and refer to p. 115
Spec · Garden hose (engine OFF) conditions={"warning":"Do not run the engine during garden hose flushing"}
Procedure · 1. After each use in salt water or dirty water, wash the outside of the outboard motor with clean, fresh water. WARNING: Do not apply water or corrosion inhibitor directly to electrical components under the engine cov...
Diagnostic · Cause: Clogged discharge port or blocked water intake screens Test: Stop the engine, check the discharge port, then tilt the outboard motor and inspect the water intake screens for clogs