Procedure
Engine Warm Up
1. Allow the engine to warm up at idling speed for three minutes before beginning operation.
Procedure
1. Allow the engine to warm up at idling speed for three minutes before beginning operation.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 4500 RPM conditions={"duration":"First 2 hours","throttle":"Varied, up to 4500 RPM or three-quarter throttle; full throttle ~1 min every 10 min"}
Diagnostic · Cause: Fuel system not primed (e.g., new engine, ran out of fuel, or fuel was drained) Test: Turn ignition to ON for ~5 seconds, then turn to START and release; engine cranks up to 8 seconds. Repeat until engine remai...
Spec · 5 minutes conditions={"duration":"Next 8 hours"}
Procedure · 1. For the first two hours of operation, run the engine at varied throttle settings up to 4500 RPM or at three-quarter throttle, and at full throttle for approximately one minute every ten minutes. WARNING: Failure to...
Diagnostic · Cause: Exhaust restriction due to exhaust relief hole being below the waterline Test: Verify exhaust relief hole is at least 25.4 mm (1 in.) above waterline with engine running at idle speed