Procedure
Procedure extracted from numbered steps
1. Center the shift cable anchor pin with the neutral detent alignment mark. 2. Locate the center point of the slack or lost motion that exists in the shift
Procedure
1. Center the shift cable anchor pin with the neutral detent alignment mark. 2. Locate the center point of the slack or lost motion that exists in the shift
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Sum of both positive and negative cables conditions={"note":"Total combined length used to determine required wire gauge from chart"}
Diagnostic · Cause: Cable barrel adjustment too far from the cable end Test: Shift remote control to neutral and check if propeller shaft turns freely Expected: Propeller shaft turns freely without drag
Spec · 50 mm (2 in.) conditions={"note":"Trim tab adjustment will have little effect reducing steering torque if antiventilation plate is approximately 50 mm (2 in.) or more above the boat bottom"}
Procedure · 1. Make a center mark 'c,' midway between marks 'a' and 'b.' Align the cable end guide against this center mark when installing the cable to the engine. 2. Position the remote control into neutral. 3. Place the barrel...
Diagnostic · Cause: Outboard is not shifted to neutral position