Procedure
5. Lock the cable in place with the cable latch. Identify anchor pin latch (a) and cable latch (b). 6. Press on the cable latch to ensure the cable latch locks onto the bracket. 7. Pull up on the throttle cable near the cable latch to confirm the cable latch has locked onto the bracket.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 3.175 mm (0.125 in.) conditions={"context":"Accessory mounting plate must not rest in the radius of the transom clamp bracket","section":"Outboard Installation"}
Diagnostic · Cause: Cable barrel adjustment too close to the cable end Test: Shift remote control into reverse while turning propeller and check if propeller shaft locks Expected: Propeller shaft locked in gear
Spec · Pull to the left conditions={"trim_direction":"Trimmed out or up","installation":"Normal installation height","propeller_rotation":"Normal right-hand rotation"}
Procedure · 1. Install cables into the remote control following the instructions provided with the remote control. 2. Shift remote control into the neutral (N) position. 3. Install the throttle cable onto the throttle cam anchor ...
Diagnostic · Cause: Shift cable barrel position too far from cable end Test: Shift remote control into forward and check if propeller shaft is locked in gear Expected: Propeller shaft locked in gear