Specification
Rigging Adapter: Screws for attaching the rigging adapter torque
6 Nm conditions={"lb-in":"53","lb-ft":"–","screws":"Two M6 x 30 and one M6 x 50"}
Specification
6 Nm conditions={"lb-in":"53","lb-ft":"–","screws":"Two M6 x 30 and one M6 x 50"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 2. Fasten the rigging grommet and rigging adapter with two M6 x 30 screws and one M6 x 50 screw. Tighten the screws to 6 Nm (53 lb-in.). (torque: 6 Nm) 3. Secure the wiring, hoses, and cables together with a cable tie...
Diagnostic · Cause: Fuel system not primed (e.g., new engine, ran out of fuel, or fuel was drained) Test: Turn ignition to ON for ~5 seconds, then turn to START and release; engine cranks up to 8 seconds. Repeat until engine remai...
Spec · 7.9 Nm conditions={"also":"70 lb-in"}
Procedure · 1. Ensure sufficient slack exists in wiring harnesses, battery cables, and hoses routed between the rigging grommet and engine attachment points to relieve stress and prevent hoses from being kinked or pinched. WARNIN...
Diagnostic · Cause: Restricted fuel flow due to added components (filters, valves, fittings, etc.) in the fuel supply system Test: Inspect fuel supply system for any added restrictive components