Diagnostic
Starter Motor Will Not Crank the Engine
Cause: Shift actuator failure Test: Turn ignition key switch off to reset and then start the engine
Diagnostic
Cause: Shift actuator failure Test: Turn ignition key switch off to reset and then start the engine
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Procedure · 1. Set the lanyard stop switch to the "RUN" position. Refer to General Information – Lanyard Stop Switch. 2. Shift the outboard to the neutral (N) position. 3. For initial start of a new engine, or an engine that ran ...
Spec · Cross hatched region on dipstick conditions={"note":"Do not fill to top of operating range; any level within cross hatched region is acceptable"}
Procedure · 1. Turn the key to the OFF position to stop the engine normally. WARNING: Turning the key to the START position while the engine is running will result in engine shut down while leaving the DTS system active. This all...
Diagnostic · Cause: Ignition key switch failure