Starter Motor Will Not Crank the Engine

Related KB links

• Engine: Shallow Water Operation - Max Engine Speed (Tilted)

  Spec · 2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}

• Stopping the Engine (DTS System)

  Procedure · 1. Turn the key to the OFF position to stop the engine normally. WARNING: Turning the key to the START position while the engine is running will result in engine shut down while leaving the DTS system active. This all...

• PCM / Engine Guardian: Overspeed Rev Limit Trigger

  Spec · Greater than or equal to the overspeed RPM limit conditions={"reference":"See Specifications section for exact RPM value"}

• Initial Engine Start / Fuel System Fill and Starting Procedure

  Procedure · 1. Set the lanyard stop switch to the "RUN" position. Refer to General Information – Lanyard Stop Switch. 2. Shift the outboard to the neutral (N) position. 3. For initial start of a new engine, or an engine that ran ...

• Starter Motor Will Not Crank the Engine

  Diagnostic · Cause: Weak battery or battery connections are loose or corroded