MFS 8/9.8B EF/EP variant: Starting System (EF/EP)

Related KB links

• Daily Pre/Post-Operation Inspection

  Procedure · 1. Fuel System – Check the amount of fuel in the tank. Replenish as needed. WARNING: Do not use outboard motor if any abnormality is found during pre-operation check or it could result in severe damage to the motor or...

• Engine starting but stopping soon

  Diagnostic · Cause: Starter motor or starter solenoid failure

• MFS 6BZ: Starting System (EF/EP)

  Spec · Electric starter motor conditions={"variant":"EF/EP","note":"With Manual Start"}

• Cooling system flush completion and drainage

  Procedure · 1. Place the shift lever in the neutral position and start the engine and run at idle speed for 3–5 minutes. 2. Check if a steady stream of water flows from the cooling water check port. 3. Stop the engine and turn of...

• Blown fuse

  Diagnostic · Cause: Short-circuit or electrical overload in the system Test: Remove fuse and visually inspect for blown condition; replace with fuse of identical specified rating only.