Specification
Outboard motor mounting fasteners: Clamp screw / mounting bolt torque
30 Nm conditions={"alternate_unit_1":"3.0 kgf","alternate_unit_2":"13 ft-lb"}
Specification
30 Nm conditions={"alternate_unit_1":"3.0 kgf","alternate_unit_2":"13 ft-lb"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Set the outboard motor to the appropriate position, ensuring 5–25 mm (0.2–1 in) clearance between the anti-ventilation plate and the water surface. 2. Tighten the clamp screws by turning their handles. Do NOT use t...
Diagnostic · Cause: Outboard motor tilted up or down while swimmer(s) or passenger is nearby; person caught between outboard motor body and clamp bracket.
Spec · 8 × 85 mm conditions={"type":"Manual tilt type"}
Procedure · 1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer
Diagnostic · Cause: Corrosion of the anode causing bolts to loosen over time Test: Manual check and re-tightening of all anode attaching bolts at each inspection