Specification
trim angle: trim_correct
Correct trim conditions={"label":"a","description":"Optimal bow and hull attitude for performance"}
Specification
Correct trim conditions={"label":"a","description":"Optimal bow and hull attitude for performance"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Assess current trim angle while underway. Observe bow attitude relative to the water surface. 2. If the bow is entering the water (trim down / trim angle too small): water may enter the boat and speed will decrease...
Diagnostic · Cause: Water or dirt in the fuel tank or fuel filter Test: Inspect and drain fuel tank; inspect fuel filter for water or dirt contamination
Spec · Trim up conditions={"label":"c","description":"Bow raised; trim angle increased via higher trim position pin setting"}
Procedure · 1. Arrange passengers and load in the boat so the weight is distributed evenly. 2. Set the tilt pin in the adjustment holes so the outboard runs perpendicular to the water at full speed, allowing the boat to run paral...
Diagnostic · Cause: Accidental or unintended activation of the lanyard stop switch Test: Inspect lanyard cord and switch for damage or wear before each use