Procedure
Flywheel Cover Installation
1. Position the cover onto the four mounting pins and secure the cover in place by pushing the cover down onto the mounting pins.
Procedure
1. Position the cover onto the four mounting pins and secure the cover in place by pushing the cover down onto the mounting pins.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 3.175 mm (0.125 in.) conditions={"context":"Accessory mounting plate must not rest in the radius of the transom clamp bracket","section":"Outboard Installation"}
Diagnostic · Cause: Outboard is not shifted to neutral position
Spec · Pull to the left conditions={"trim_direction":"Trimmed out or up","installation":"Normal installation height","propeller_rotation":"Normal right-hand rotation"}
Procedure · 1. Lift the cover off the four mounting pins (two on each side of the engine).
Diagnostic · Cause: Lanyard stop switch not in RUN position