Specification
trim angle: trim_down
Trim down conditions={"label":"b","description":"Bow enters water; speed decreases; risk of water entering boat"}
Specification
Trim down conditions={"label":"b","description":"Bow enters water; speed decreases; risk of water entering boat"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Arrange passengers and load in the boat so the weight is distributed evenly. 2. Set the tilt pin in the adjustment holes so the outboard runs perpendicular to the water at full speed, allowing the boat to run paral...
Spec · Trim up conditions={"label":"c","description":"Bow raised; trim angle increased via higher trim position pin setting"}
Procedure · 1. Assess current trim angle while underway. Observe bow attitude relative to the water surface. 2. If the bow is entering the water (trim down / trim angle too small): water may enter the boat and speed will decrease...
Spec · Correct trim conditions={"label":"a","description":"Optimal bow and hull attitude for performance"}
Procedure · 1. Raise the outboard and pull up on the tilt release lever. Gently lower the outboard down.